A mold refers to an auxiliary tool for plastic products with corresponding shapes and specifications. Because of the rapid development of 3D software, some of the shapes of the products we need will become more and more complicated. Compared with this type of mold The specification will only become higher and higher, and the rationalization of the mold design concept and the quality of its production and processing will interfere with the work efficiency of plastic products. Therefore, which aspects should injection mold manufacturers pay special attention to?
1. The appearance of plastic products is beautiful and generous, which can realize the design and specification of plastic products. Nowadays, the specifications for plastic products are not only limited to the level of ease of use, but also the appearance specifications are getting higher and higher. The distinctive appearance is easier to attract the special attention of consumers.
2. The size of the product is relatively stable and accurate, and the amount of deformation is small. The quality of plastic products cannot be ignored. Although it is plastic, it will greatly interfere with the subsequent sales of the product if it is deformed during the application process.
3. The mold re-use link is safe and reliable, the operation is relatively stable, and the service life is long, which is conducive to maintenance. The quality of the mold in the production process cannot be ignored by the manufacturer, and it is safe and reliable in the application process to ensure the safety of the customer in the application process. In the general application process, if the mold produces any product quality problems, the manufacturer will also It should be overhauled immediately.
4. In the injection molding process, the mold has a short shaping cycle time, a fast manufacturing speed, and a low failure rate. Manufacturing a pair of molds has been producing waste products, which is relatively high relative to the cost of the manufacturer. In the mold products, the production speed is standardized, so the mold accommodation link must achieve such a specification that the cycle time is short.
Like the injection molding process, which is often used in the production and processing of plastic products, it is more suitable for any thermal plastics and certain solid plastics. Like the plastic products we see in our lives, most of them are produced by injection mold manufacturers. The mold can be more suitable for the production level of some plastic products that are complex, complicated in shape, and diverse in color. Compared with the specifications and sizes, there are very standard specifications.